Minox DC 9011 Guide de l'utilisateur télécharger pdf (Page 6)

EN-6

Important Information on Underwater Instructions

Before using the camera underwater, please make sure to read the following the

instructions carefully.

Before Using in Water:

1. Make sure there is no foreign material such as dirt or sand on the waterproof seal of

the battery/memory card cover. Water, dirt, or sand may cause failure of the

camera’s waterproof function.

2. Carefully inspect the waterproof seal of the battery/memory card cover for damage

(cuts, tears, dents, and any other imperfection). Do not use the camera underwater

if the waterproof seal is damaged. Please contact your local retailer or service

center for repair.

3. Make sure that the battery/memory card cover is securely locked before using it in

an environment where it is likely to get wet or dirty, such as underwater or at the

beach.

4. Avoid opening the battery/memory card cover near water (at the beach, by the sea,

lake, or any wet areas) or with wet hands.

5. Do not jump into the water while holding the camera. Sudden, strong water

pressure may cause failure of the camera’s waterproof function.

During Using in Water:

1. Do not open the battery/memory card cover underwater.

2. Avoid subjecting the camera to substantial shocks as this may cause the battery/

memory card cover to open.

3. Do not use the camera at depths over 10ft/3m. This may cause failure of the

camera’s waterproof function.

4. Do not use the camera at warranted depths for over 60 minutes.

5. The camera will sink if dropped in water. Make sure to attach the strap and slip the

strap over your wrist when using the camera in or near water.

6. If the camera cannot operate normally or a malfunction has occured while

underwater, long press the Power button to turn off the camera. Turn the camera on

again. If the problem persists, contact your local retailer or service center.

After Using in Water:

1. After the camera has been used underwater or dropped on sand, use fresh water to

clean the camera. Make sure the power is turned off and the battery/memory cover

is firmly closed before cleaning.

2. The camera should be soaked and rinsed in a bucket of fresh water for a few

minutes. Do not soak the camera for too long or pour water over the camera directly

from the water faucet.

3. Make sure to use only clean, fresh water to rinse the camera. Do not use any

cleaning agent. This may cause damage to the camera.

4. Use a piece of clean, dry cloth to wipe off remaining water or sand.

5. Make sure the camera is completely clean and dry before opening the battery/

memory card cover.

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Pas de commentaire

Minox DC 9011 Guide de l'utilisateur Page 6